V-TAC VT-6056-4 Manuel D'instructions page 12

STEP 6. BLADE ASSEMBLY INSTALLATION
• Remove the large screws in the face of the motor.
• Discard any rubber blocks attached to these screws.
• The rubber blocks are installed at the factory to stabi-
lize the motor during shipment. Select the correct
mounting pattern and attach each blade to the motor
face using pre-installed screws (see figure 15). Take
care not to bend the blade arms during installation. This
will cause your fan to wobble while running. Try mount-
ing the blades on the opposite side of the motor face.
This will help keep the fan more level during blade
installation.
STEP 7. INSTALLATION OF LIGHT FIXTURE
Depending on which model of Heritage Square you are installing, you will either have the 4 light
Turtle Cluster (see figure 16 & 17) or the Bowl Light (see figure 18 & 19). Please follow instruc-
tions under the correct light fixture.
TURTLE CLUSTER:
• Connect white wire to white wire and blue wire to black wire. Secure with wire nuts.
• Remove switch housing screws. Press fixture up into switch housing shell, aligning screw
holes. Insert (3) screws and tighten firmly (see figure 16).
• Slide glass shades over sockets and tighten set screw until snug to glass. Install 60 watt bulb
(see figure 17).
FIG. 15
ENGLISH