V-TAC VT-6056-4 Manuel D'instructions page 7

Pull the electric wires in the junction box down through
the mounting bracket then bend them up and back out of
the way. Place the black wire to one side and the white
and ground wire to the other side (see figure 5). The wires
should be off to the side and up against the ceiling. This
will leave the mounting bracket open and ready to receive
the ceiling fan.
STEP 2. ATTACHING THE SUPPORT ASSEMBLY
• If you are using an extended support rod, (longer than
the one supplied with your fan) remove the halt ball
from support assembly and attach it to the extended
support rod at this point. Make sure to retighten the set
screw and insert the safety pin.
• Back off (loosen) the set screws (2) in the support rod
coupler until the inside of the channel is clear of the
screw tip.
• Remove and save the safety pin on the end of the
support rod assembly.
• Place the ceiling canopy face down (small end) over
the support rod coupler on the motor housing.
• Feed the electrical wire from the fan housing through
the support rod.
FIG. 5
FIG. 6
RETAINING CLIP
& WASHER
MOTOR LEADS
CEILING CANOPY
FAN MOTOR
ASSEMBLY
SUPPORT ROD COUPLER
ENGLISH
HALL BALL HANGER
SAFETY PIN
THREADED END
OF SUPPORT ROD
SUPPORT ROD
COUPLER COVER
SUPPORT ROD
SET SCREWS