Publicité
Page | 4
PICTURE 11
FITTING INSTRUCTIONS
•
REMOVE THE RIDER SEAT USING KEY AND REMOVE THE PILLION
SEAT/SEAT COWL.
•
REMOVE THE TWO BOLTS ARROWED IN PICTURE 1 USING A 4mm ALLEN
KEY AND REMOVE THE SEAT LOCK BRACKET.
•
REMOVE THE BOLTS LABELLED A IN PICTURE 1 USING A 4mm ALLEN KEY,
REMOVE THE PLASTIC BRACKET FROM THE SUB-FRAME AND DISCONNECT
BOTH INDICATOR CONNECTORS. PLEASE NOTE THE ORIENTATION OF THE
CONNECTORS BEFORE REMOVAL.
•
DISCONNECT THE TWO BULLET CONNECTORS FOR THE OEM LICENCE
PLATE ILLUMINATOR.
•
REMOVE THE FOUR BOLTS ARROWED IN PICTURE 2 USING A 5mm ALLEN
KEY. PLEASE NOTE TO KEEP THE OEM LICENCE PLATE BRACKET SUPPORTED
DURING THIS PROCESS. REMOVE THE OEM LICENCE PLATE BRACKET AND
ITS WIRING AWAY FROM THE SUB-FRAME.
IF FITTING OEM INDICATORS:
•
ON THE UNDERSIDE OF THE OEM LICENCE PLATE BRACKET, UNCLIP THE
PLASTIC COVER (ARROWED IN PICTURE 3) AND REMOVE FROM THE
BRACKET.
•
REMOVE ALL WIRING FROM THE PLASTIC CLIP ARROWED IN PICTURE 4.
•
TO REMOVE OEM INDICATORS, REMOVE THE PLASTIC MOUNTING PLATE
FROM THE RUBBER HOUSING AS ARROWED IN PICTURE 5. GENTLY
SQUEZZE OUT THE RUBBER HOUSING FROM THE OEM LICENCE PLATE
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
9
PICTURE
R&G Racing
PICTURE
www.rg-racing.com
Email:
LP0229
10
info@rg-racing.com
Publicité
