Safety Instructions For Maintenance; Operation - Husqvarna PG 540 Manuel D'utilisation

To do a check of the emergency stop button
1. Turn the emergency stop button (A) on the control
panel clockwise to make sure that the emergency
stop button is disengaged.
2. Turn the ON/OFF switch (B) on the control panel to 1
to start the motor. The LED adjacent to the ON/OFF
switch comes on.
3. Push the emergency stop button.
4. Make sure that LED adjacent to the ON/OFF switch
goes off.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To remove the product from the
package
WARNING: Move the product from the pallet
carefully and safely. The product is heavy
and can cause serious injury if it falls.
• Make sure that all items that is shown in the product
overview, are included. Refer to
right side on page 3 . Speak to your Husqvarna
dealer if an item is missing or damaged before you
move the product from the pallet.
• Remove all package straps and wheel chocks.
• Make sure that the area is clear and that you have
sufficient space to move the product.
• Make sure that there is no risk that you or the
product can fall.
• Use lifting equipment or ramps to move the product
from the pallet. The product is heavy. Move the
product safely. Refer to
21 .
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
1211 - 002 - 24.10.2019
A
B

Operation

Product overview,
To lift the product on page
5. Turn the emergency stop button clockwise to
disengage.

Safety instructions for maintenance

• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved service agent.
• Stop the product when you replace the diamond
tools. Turn the ON/OFF switch to 0 and push the
emergency stop button.
• Do the inspection and/or maintenance with the motor
stopped and the power plug disconnected.
• Do the maintenance to make sure that the product
operates correctly. Refer to
on page 16 .
2. Put on necessary personal protective equipment.
Personal protective equipment on page 6 .
Refer to
3. Make sure that only approved persons are in the
work area.
4. Do daily maintenance. Refer to
schedule on page 16 .
5. Make sure that the product is assembled correctly
and is not damaged.
6. Put the product on the work area. Make sure that the
transportation of the product to and in the work area
is done safely and correctly. Refer to
on page 20 .
7. Make sure that there are diamond tools on the tool
plates and the diamond tools and the tool plates are
tightly attached.
8. Connect a dust extractor to the product. Refer to
connect a dust extractor on page 11 .
9. Adjust the handle and the handlebar to an applicable
operation height. Refer to
the handlebar on page 12 .
10. Make sure that the motor cable is connected to the
electrical enclosure before the product is connected
to a mains outlet. Refer to
grinding head on page 17 .
11. Connect the product to a power source. Refer to
connect the product to a power source on page 13 .
Maintenance schedule
Maintenance
Transportation
To
To adjust the handle and
To install and remove the
To
9