Troubleshooting; Storing; Waste Disposal And Environmental Protection; Repair Service - IKRA GESI 1000 Manuel D'utilisation

11. TROUBLESHOOTING

PROBLEM
Line will not advance when
tap bump button
Bump head is hard to turn
Grass wraps around the
attachment shaft and the
trimmer head assembly
Unit stops and will not start
again

12. Storing

• Clean the unit thoroughly, especially the cooling air
slots on the motor housing.
• Do not use water to clean the device.
• Store trimmer indoors in a dry, high or locked place
and keep out of reach of children.

13. Waste disposal and environmental protection

Dispose of the machine properly after it is worn out. Dis-
connect the mains cable in order to prevent misuse. Do
not dispose of the machine with the household waste. In
the interest of environmental protection, take it to a col-
lection point for electric machines. Your responsible local
authority can provide you with addresses and operating
times. Also take the packaging materials and worn out
accessories to the appropriate collection points.
Only for EU countries
Do not discard electric tools in the household
waste!
In accordance with European Directive 2012/19/EC on
waste electrical and electronic equipment and its im-
plementation in national law, waste electric tools must
be collected separately for environmentally-compatible
re-use.
Recycling alternative to the return invitation:
Instead of returning the electric equipment, the owner is
alternatively obligated to take part in the proper recycling
in the case of relinquishment of ownership. The waste
equipment can also be taken to a collection facility which
GB | Operating Instructions
POSSIBLE
• Line is welded to itself.
• Not enough line on spool.
• Line is worn too short.
• Line is tangled on spool.
• Grass wrapped or built up around
head.
• Cutting tall grass at ground level.
• Overload protection activated
• Fuse from main supply blown
• Unit failed
GB-11
CAUSE SOLUTION
• Lubricate with a silicone spray
• Install more line (Refer to "Repla-
cing the Cutting Line" earlier in this
manual).
• Pull lines while alternately pressing
down on and releasing bump button.
• Remove line from spool and rewind
(Refer to"Replacing the Cutting
Line"earlier in this manual).
• Clean affected parts of the machine.
• Cut tall grass from the top down.
• Wait 10 minutes before restarting
• Check fuse
• Contact dealer to check damage
disposes of it in the sense of the national recycling man-
agement and waste acts. This does not pertain to the ac-
cessory parts and auxiliary equipment without electrical
components accompanying the waste equipment.

14. Repair service

Repairs to electric power tools should only be carried out
by a specialised electrician.

15. Spare parts

Please contact our service department if you need acces-
sories or spare parts.
When working with this machine, do not use spare parts
other than those recommended by us. Using spare parts
not recommend by us can result in serious injuries to per-
sons or damage to the machine.
The following information should be provided when or-
dering spare parts:
• Type of machine
• Item number of the machine

16. Warranty

For this tool, the company provides the end user - inde-
pendently from the retailer's obligations resulting from
the purchasing contract - with the following warranties:
The warranty period is 24 months beginning from the
hand-over of the device which has to be proved by
the original purchasing document. For commercial use
and use for rent, the warranty period is reduced to 12