Loewe klang bar5 mr Guide De L'utilisateur page 18

Loewe klang bar5 mr

Main unit Components
3 Main unit Components
3.1 Main unit front panel
1. (Standby) button/indicator– Switches the
soundbar on or switches to standby mode.
2. (Source) button - Press to change input
source.
Press and hold in standby mode to show
the software version on the display.
3. (Play/Pause) button - Play/pause audio
track in USB / Bluetooth / PLAY-Fi mode.
3.2 Main unit rear panel
1. Rear flap – You will need to remove the rear
flap of your Sound Bar before using WDAL 2.0
control keys.
2. WDAL 2.0 control keys - Use these switches to
connect additional external wireless speakers
via the WDAL2.0 as SUB / REAR / FRONT /
CENTRE channel. Set the switch to SMALL for
small speakers, LARGE for large speakers. To
disconnect the speaker for a specific channel,
set the switch to OFF.
3. PAIRING button - for WDAL 2.0 pairing
4. WPS (Wi-Fi Protected Setup) button/in-
dicator – Triggers Wi-Fi setup for Play-Fi.
Press and hold the button for 3 seconds to acti-
vate the WPS mode.
Press and hold the button for 8 seconds to acti-
vate the AP mode.
17
1 2 3
5
Press and hold for 8 seconds in stand-
by mode to restore the factory settings.
Press and hold to activate the pairing function in
Bluetooth mode or disconnect the existing paired
Bluetooth device.
2
5 6 7 8 9 10
LED indicator state Status
Wi-Fi Access Point (AP)
LED slowly pulsing
mode
Wi-Fi Protected Setup
LED flashes twice
(WPS) mode
Connected / Pairing
LED is on
successful
5. AUX IN – connect to the audio source via 3.5mm
audio cable.
6. USB – connect a USB storage device.
7. HDMI OUT (TV eARC/ARC) – connect to the
HDMI jack on a TV.
8. HDMI IN 1 / HDMI IN 2 – connect to the HDMI out-
put of an external devices (e.g. game consoles,
DVD and Blu-ray players).
4
6
4. -/+ (Volume) button – Reduces/increases the
volume level.
Press both buttons simultaneously
to mute / unmute the soundbar.
5 . Front panel display
6 . Remote control sensor - Point the remote
control at the remote control sensor to operate
the system.
1
9. OPTICAL – connect to the digital (optical) output
of an external device.
10. AC IN – connect to the power supply.
3
4