Gardena HandyMower 22/18V P4A Mode D'emploi page 11

Be careful while going backwards.
Do not let the product become wet with rain or other moisture.
DANGER! Risk of explosion!
Do not operate the product in explosive atmospheres, such as in the
presence of flammable liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
2. ASSEMBLY
DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v Remove the battery, remove the safety key and use gloves
before you assemble the product.
To assemble the tube [ Fig. A1 / A2 ]:
1. Slide the tube (1) into the tube holder
point forward from the handle
Make sure that the tube (1)
on the tube are located in the openings
2. Tighten the clamping sleeve
3. OPERATION
DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v Wait for the blade to stop, remove the safety key and use
gloves before you adjust or transport the product.
To charge the battery [ Fig. O1 / O2 / O3 ]:
CAUTION!
v Note the mains voltage! The voltage of the power source must
match the voltage specified on the rating plate of the charger.
For the GARDENA Battery Mower Art. 14620-55 there is no battery
and no charger in the scope of delivery.
Thanks to the intelligent charging process, the charge condition of the
battery is automatically detected and then charged up with the optimal
charge current depending on battery temperature and voltage.
In this way, the battery is treated with care and remains permanently fully
charged when it is stored in the charger.
1. Open the cover (4) .
2. Push the locking button (A)
holder (D) .
3. Connect the battery charger
(C)
4. Slide the battery charger
When the battery charge indicator
the battery is being charged.
When the battery charge indicator
permanently green the battery is completely charged
(Charging time, see 7. TECHNICAL DATA).
5. Examine the charge status regularly while you charge.
6. When the battery (B) is completely charged, you can disconnect the
(B)
battery from the charger
Meaning of the indication elements:
Indication on the charger [ Fig. O3 ]:
Flashing of the battery The charging procedure is indicated by flashing of the battery charge
(Lc) (Lc)
charge Indicator indicator
Note: The charging procedure is only possible when the battery
temperature is within the allowable charging temperature range,
see 7. TECHNICAL DATA.
Continuous lighting Continuous lighting of the battery charge indicator
of the battery the battery is fully charged or that the temperature of the battery is
(Lc)
charge indicator
not within the allowable charging temperature range and can therefore
not be charged.
When the battery is not inserted, continuous lighting of the battery
charge indicator
socket outlet and that the battery charger is ready for operation.
14620-20.960.01.indd 11
(2) . The starting lockout
(5)
.
is completely inserted and that the noses
(m)
of the tube holder
(3) .
and remove the battery (B) from the battery
(C) into a mains socket.
(B)
onto the battery .
(Lc) at the charger flashes green
(Lc) at the charger illuminates
(C)
.
.
(Lc)
indicates that
(Lc) indicates that the mains plug is inserted in the
Battery charge status indication
After starting the product, the battery charge status indication
is displayed for 5 seconds.
Battery charge status
67 – 100 % charged
34 – 66 % charged
11 – 33 % charged
0 – 10 % charged
If the LED (L1) flashes green, the battery must be charged.
(Wp)
If the error LED is illuminated or flashing, see 6. TROUBLESHOOTING.
Work positions:
The product is provided with a safety device to prevent it from
being switched on in the position at working interruption and
transport position.
Working position (W)
In order for the mower to be started, the tube
(7) must
working position (W)
For safety reasons, the mower stops automatically when the tube
(n)
moved out of the working position
(2)
.
Parking position (P)
(1)
When the tube is completely up, the tube
position (P) . The mower cannot be started in this position.
Transport position
For transport, the mower can be carried by the tube
handle (5) .
When the mower is carried, the handle
The mower cannot be started in this position.
To adjust the cutting height [ Fig. O8 ]:
The cutting height can be adjusted from 30 – 50 mm in 3 positions.
1. Push the height adjustment
the height adjustment
2. Let the height adjustment
To start the mower [ Fig. O1 /O9 ]:
DANGER! Risk of injury!
Risk of injury if the product does not stop when you
release the start lever.
v Do not bypass the safety devices or switches. For example
do not attach the start lever to the handle.
To start:
The product is provided with a two-switch safety device (safety
key with starting lockout) to prevent the product from being turned
on by accident.
1. Open the lid (4) .
2. Put the battery (B)
3. Put the safety key
4. Push the starting lockout
with the other hand.
The mower starts and the battery charge status indication
displayed for 5 seconds.
5. Release the starting lockout
To stop:
1. Release the start lever
The mower stops.
2. Turn the safety key
Tips to use the mower:
To produce a well-maintained lawn and optimise the cutting performance,
we recommend to cut the lawn regularly once a week if possible. The lawn
becomes denser if you cut it frequently.
After relatively long cutting intervals (holiday lawn), first of all cut in one
direction with the highest cutting height and then cut in the crosswise
direction with the required cutting height.
If possible, only cut the grass when it is dry, if the grass is damp, the
cutting pattern will be uneven.
(P)
on the product [ Fig. O4 / O8 ]:
Battery charge status indication
(L1) (L2) (L3)
, and illuminate green
(L1) and (L2) illuminate green
(L1) illuminates green
(L1)
flashes green
approx. 22° – 70° [ Fig. O5 ]:
(1) must be in the
(approx. 22° – 70°).
(W)
.
approx. 70° – 105° [ Fig. O5 / O6 ]:
(1) is in the parking
(T) approx. 0° – 22° [ Fig. O5 / O7 ]:
(1) or by the
(1) is in the transport position
(11) in the direction of the wheel and set
(11) to the desired position.
(11) engage in the desired position.
into the battery holder (D) until it audibly engages.
(6)
into the handle and turn it to position
(7) with one hand and pull the start lever
(7) .
(8) .
(6) to position and remove it.
(P)
(1) is
(T) .
.
(8)
(P) is
11
04.09.20 09:24