External Speaker Jack - Traynor YGL 2 Mode D'emploi

Overdrive Gain and Volume
The Gain control controls the amount of tube saturation in your sound and the volume control
controls the level sent to Master control.
Tone Controls and Vintage/Modern Switch
The Treble, Bass, and Middle tone controls are to help you shape your sound. The
Vintage/Modern switch will give you two choices for the range of frequencies that the
tone controls work in.
Reverb Control
The Reverb control adjusts the overall reverb level. The YGL2 is equipped with an
Accutronics® spring reverb for authentic vintage reverb.
Amp In / Out Send & Return Jacks
The Amp In and Amp Out (send and return) jacks of the YGL2 allow convenient use of external
effect units. Simply connect a 1/4-inch phone cable to the Send jack of the YGL2 and then connect
this cable to the Input of your effects unit. To send the processed signal back to the YGL2, connect
the output of the effects unit to the Return jack of the YGL2.
The Amp Out (send) Jack can also be used as a direct line out (preamp-out). The -10dBu
output is ideal for most guitar effects pedals and professional signal processors. You can also
use this output to slave the YGL2 with another guitar amplifier by plugging into the Amp In
(return) jack of the slave amplifier.
The 1/4 inch TRS Amp In (return) jack is usually used as the return for your effects loop. It
allows an input signal to pass directly to the power amplifier. The master Volume control section
regulates the signal, so you can add Reverb.
Footswitch Jack
Connecting a footswitch to the 1/4-inch TRS Footswitch jack will allow you to defeat the
internal reverb and switch between the 'Clean and Overdrive' channels.
The switching is accomplished with internal FETs so there is no audio flowing through the
footswitch cable. Footswitch-induced noise is never an issue. The YGL2 is compatible with
most aftermarket latching dual-footswitch pedals.

External Speaker Jack

The chassis mounted ¼ inch jacks allow convenient connection of an 8-ohm external speaker
cabinet. If you disconnect the internal 12-inch Celestion® speaker, you can connect up to two
8 ohm external cabinets.
Warranty Two-year, unlimited (
even if you break it!
Transferable warranty*
(
Valid in USA and Canada only
3
)
)