TEFAL PRESSING COMPACT Notice D'emploi page 26

11- IS THERE A PROBLEM ?
Problems
Water runs through the holes in the
■
soleplate.
■
White streaks come through the holes
■
in the soleplate.
Brown streaks come through the holes
■
in the soleplate and stain the linen.
■
The soleplate is dirty or brown and may
■
stain the linen.
There is little or no steam.
■
Steam escapes from the boiler cap.
■
Steam escapes under the appliance.
■
Never dismantle your iron : always take it to an Approved Service Centre.
HELPLINE
If you have any product problems or queries with your product, please telephone our
Customer Relations team on :
0845 602 1454 (UK) (Calls charged at local rate)
Consult our web site : www.tefal.co.uk
All manuals and user guides at all-guides.com
Possible causes
The boiler is too full.
■
The thermostat is not working :
■
the temperature is always too
low.
You are using the steam control
■
button before the iron is hot.
You are using the steam contol
■
button on too low a temperature.
The water has condensed in the
■
pipes because you are using steam ■from your ironing board until
for the first time or you have not
used it for some time.
Your boiler has a build-up of scale
■
because it is not rinsed out regularly. 10 uses. If your water is hard,
■
You are using chemical descaling
■
agents or additives in the water for
ironing.
You are ironing at too high a
■
temperature.
Your linen is not rinsed sufficiently
■
or you are using starch.
The boiler is empty
■
The boiler is not yet ready.
■
Cap screwed on incorrectly.
■
The seal on the cap is damaged.
■
The equipment is faulty.
■
Solutions
Do not fill the boiler right up to
■
the top.
Contact an Approved Service
■
Centre.
Wait for the thermostat light to
■
go out before activating the steam
control button.
Enure that the thermostat control
■
is set within the coloured zone.
Press the steam control button away
■
the iron produces steam.
■
Rinse out the boiler after every
■
increase the frequency.
Never add this type of product in
■
the boiler (see our recommenda-
tions regarding water to be used).
See our recommendations regarding
■
temperature control setting.
Always spray starch onto the reverse
■
side of the fabric to be ironed.
Fill the boiler.
■
After switching on, wait for the
■
steam indicator light to go out
(after 8 mins.).
Screw the cap back on.
■
Change the cap seal.
■
(Spare seals supplied with the
steam generator in the box).
Stop using the generator and
■
contact an Approved Service
Centre.
(01) 475 1947 (Ireland)