TEFAL PRESSING COMPACT Notice D'emploi page 24

Never unscrew the boiler cap while the iron is producing steam.
1. Press the on/off switch to stop the generator (depending on the model).
2. Disconnect the generator from the mains.
3. Slowly unscrew the boiler cap (note: some hot steam may still escape).
4. Using a water jug, fill with one litre of tap water.
5. Fill the boiler, taking care that the water does not spill over.
If this occurs, remove the excess water.
6. Replace the boiler cap, screwing on tightly, reconnect your generator to the mains, and switch it on.
7.Wait a few minutes until the boiler heats up.
The generator and the iron are ready to use when both the thermostat indicator and the steam indicator lights go
out.
7- MAINTAINING YOUR STEAM GENERATOR
• Before cleaning, ensure that the appliance is unplugged and that the soleplate and the iron
rest have cooled down.
• Do not use any cleaning or descaling products for cleaning the soleplate or the boiler.
• Never hold the iron or the base unit under the tap.
• Do not place the iron on a metal rest as this could damage it.
Place it on the iron rest on the base : it has non-slip pads and has been designed to withstand high
temperatures.
The iron soleplate : regularly clean the soleplate with a damp, non-metallic washing up pad.
The base unit : clean the plastic parts occasionally with a slightly damp cloth.
8- RINSING OUT THE BOILER
Be careful :
• To extend the life of your boiler and to avoid the building up of scale, it is essential that
you rinse out the boiler after every 10 uses. If your water is hard, increase the frequency.
• In particular, do not use descaling agents for rinsing out the boiler, as they could
damage it.
1. Check that the steam generator is cold and unplugged for more than 1 hour.
2.With a jug, fill the boiler 3/4 full with tap water.
3. Shake the base unit for a few moments and then empty it completely over a suitable container 7 .
To obtain the best results, we advise you to repeat this operation.
9- PUTTING YOUR STEAM GENERATOR AWAY
1. Press the on/off switch to stop your generator (depending on the model).
2. Unplug it.
3. Place the iron on the iron rest plate.
4. Leave the iron (and the iron rest) to cool down for 30 minutes.
You can now store your steam generator.
All manuals and user guides at all-guides.com