Yakima SteelHead Manuel D'installation page 2

inseRt sKeWeR: Twist & Push.
insert skewer into steelHead
by twisting and pushing
(it may be tight at first).
Skewer
direction is
your choice:
Consider
lock access.
ReLeAse BAR CLAMP: Open The Jaw.
• Lift loop handle
• Loosen
up & open.
adjusting knob
until it stops.
AttACH: Jaw bites bar.
• Close onto bar:
silver clasp must
snAP.
• Close red
lever to
secure jaw.
test clamping on
bar for tightness.
foR Added
seCURity—
attach to bar
between
towers.
1031955F-/8
• Lift loop UP.
• thread adjustment
knob completely.
• security pin must enter small hole!
• PUsH lock
housing inward.
AsseMBLe & AttACH ReAR:
Red lever UP will loosen
bike mount on bar.
WARninG:
attach
Silver clasp
Snaparound
must engage
to opposite
the lower
bar.
jaw
securely
to the bar
for safe
transport.
insert bolt head
into slot in tray.
slide the "C"Clip into groove
on skewer tip.
Groove at tip of
skewer is visible only
when loop is up and knob is tight.
PUsH SilveR claSP
PULL red lever oPen.
to release Jaw.
TE: Loop handle must be up and in before
NO
the Jaw can be opened or closed.
Bolt threads go
into square hole
in Snaparound.
secure with Hex
Key (nut).
oPen
Jaw.
instALL
end Cap
sLide Wheel
strap into tray:
Consider where
rear tire will be.
Strap may need
to go on
before securing
tray to bar.
LooP MUst
Be UP!