Cycling Mode; Training Mode - Blatchford Orion3 Guide De L'utilisateur

7.2

Cycling Mode

WARNING: In cycling (free swing) mode there is NO stance resistance.
To activate/de-activate Cycling Mode use the [-] button on the device, as follows:
To activate Cycling Mode:
• Sit on bicycle before activating Cycling Mode as once activated there is no support for
walking.
• Press the [-] button 4 times (each time pressing until the device responds with a single short
beep).
• 4 medium beeps then sound to confirm that Cycling Mode is ON.
To de-activate Cycling Mode:
• Press and hold the [-] button.
• 2 long beeps then sound to confirm that Cycling Mode is OFF and normal operation has
resumed.
WARNING: After exiting Cycling Mode, always test/confirm that the limb is operating
normally again before walking.
7.3

Training Mode

WARNING: In Training Mode, the device has a predefined fixed pneumatic resistance
setting which does not adapt to changes in walking speed. Also, Standing Mode is not
active in Training mode.
To activate/de-activate Training Mode use the [-] button on the device, as follows:
To switch ON Training Mode:
• Press the [-] button 5 times (each time pressing until the device responds with a single short
beep).
• 5 medium beeps then sound to confirm that Training Mode is ON.
To switch OFF Training Mode:
• Press and hold the [-] button.
• 2 long beeps then sound to confirm that Training Mode is OFF and normal operation has
resumed.
WARNING: After exiting Training Mode, always test/confirm that the limb is operating
normally again before walking.
12
938375V2APK1/1-0321