Table des Matières
Publicité
REMIND
1. Above working modes are factory default settings, user can re-set it to: press button on
the lamp 1st time for mode B and press 2nd time for mode A, meanwhile also can select
different working time or brightness by remote control, after which it will automatically
become the latest default working mode.
2. Mode A and Mode B cannot be set to the Constant Lighting Mode at the same time, nor
can they be set to the Sensor Mode at the same time.
3. The lamp has memory function. After lamp restarted, it will continue to work in the latest
default working mode.
DIY WORKING TIME AND BRIGHTNESS BY REMOTE CONTROL
Remote Control Distance: 12 Meters
ON/OFF
Switch Confirm
Sensor Mode
Constant Lighting Mode
Time
2H
4H
6H
8H
10H
12H
Brightness
NOTICE
1. The lamp button is power-off switch, lamp can get solar charged in any mode.
2. This is a solar powered lamp, please install it in a location where can get enough
sunshine.
3. Please note the lighting time depends on the sunshine duration & weather.
4. Built-in intelligent IC is with over-charge, over-discharge and over-voltage protection.
5. The lamp gets solar charged at day time, and lights up automatically at dusk.
6. The lamp is equipped with an internal battery pack, which is replaceable. If any need,
please contact seller for correct new battery pack.
7. Non-professionals please do not disassemble the lamp.
8. Please do not dispose the battery with household garbage to avoid explosion.
PACKAGE CONTENT
SOLAR PANEL
LED SOLAR STREETLIGHT
EN
Mode A (Constant Lighting Mode): time and brightness are
both adjustable.
FOR EXAMPLE:
① Press button "Constant Lighting Mode";
② Press button "Time 2H".
③ Press button "Brightness 60%".
The lamp will flash one time after press each button above, which
indicates it's set successfully as below: Lamp automatically turns
on at night and keep 60% brightness for 2hrs, then it turns to
Sensor Mode.
Mode B (Senor Mode): only brightness(when activated by
induction) is adjustable.
FOR EXAMPLE:
① Press button "Sensor Mode";
② Press button "Brightness 60%".
The lamp will flash one time after press each button above, which
indicates it's set successfully as below: Lamp automatically turns
on with 60% brightness when motion is detected in the range ≤
12mtrs, then turns to weak brightness (30% of 60% brightness)
in 20 seconds of no motion.
REMOTE CONTROL
ALLEN WRENCH
U SHAPE BRACKET
INSTRUCTION
MANUAL
MANUAL
Publicité
Table des Matières
