Apex Pro-care Optima Mode D'emploi page 14

Pro-care Optima / English
4. Installation
4.1 Pump & Mattress Installation
NOTE- Unpack the box to inspect for any damage which may have occurred during shipment. If
there are any damages, please contact your dealer immediately.
1. Place the mattress on top of bed frame and foot print toward foot end. Secure the mattress
firmly by fixing the straps to bed frame to ensure mattress will be free from sliding. Securing
straps are located on the base of the mattress
NOTE- Make sure that ALL the Relief kbobs and emergency CPR knob are closed and locked
in position.
CAUTION- Placing another layers of sheet or bed linen between the patient and the
mattress may reduce the benefits provided by the mattress and should be avoided at all time.
2. Hang the pump onto bed panel at the foot-end and adjust hangers to hang the pump to best
upright position, or place the pump on a flat surface.
3. Connect the air hose connector of air mattress and the electrical cord of position sensor to
the pump unit. Make sure the air hose connection is completed and secured when a "click"
sound is felt or heard and position sensor assemble the alignment with the arrow pointing up.
NOTE- Check and ensure the air hose is not kinked or tucked under mattress.
NOTE- Auto recognition mattress of Pro-care optima or Pro-care Optima Prone.
4. Plug the power cord into electrical outlet.
NOTE- Make sure the pump unit is suitable for the local power voltage.
NOTE- The plug is also served to stop the device.
1
4
2
5
12
3
6