en
Problem
Display shows
"12:00"
Display shows
"Milk container connected?"
despite connected milk
container�
Display shows
"Overvoltage or undervoltage"
Display shows
"Leave device to cool"
Display shows, for example:
"Fault: E0510"
Display shows
"Fill bean container"
although the container is
already full, or the grinder is
not grinding any beans�
Display shows
"Clean brewing unit"
Display shows
"Refill with still water or
remove filter "
Cause
Power failure or appliance
switched off at power switch�
Container is outside the
range of the sensor�
Material e�g� milk carton is
not recognised�
Voltage too high or too low�
Appliance is too hot�
The appliance has a fault�
Beans are not falling into the
grinding unit (beans too oily)�
Brewing unit is soiled�
Too much ground coffee in
the brewing unit�
The mechanism of the
brewing unit is stiff�
Water tank wrongly inserted
Carbonated water in the
water tank�
Float is stuck in the water
tank�
New water filter not rinsed
according to instructions, or
water filter used or defective.
Air in the water filter.
Solution
Re-enter values; do not
switch the appliance off at
the power switch or select
the "Off" option in the Clock
display menu�
Position the container at the
right edge�
Confirm the display request
with "yes" or use the enclosed
milk container�
Contact electricity or grid
provider� Have the power
supply checked by an expert�
Switch off appliance for
30 minutes�
Proceed according to the
display screen�
Gently tap the bean
container� Possibly change
the type of coffee� When
the bean container is empty,
wipe it with a dry cloth�
Clean the brewing unit�
Clean the brewing unit� Do
not place more than two level
measuring spoons of ground
coffee in the drawer�
Clean the brewing unit, see
the section "Care and daily
cleaning"�
Insert water tank correctly
Fill the water tank with fresh
tap water�
Remove the tank and clean
thoroughly�
Rinse the water filter
according to the instructions
and then switch on, or use a
new water filter.
Dip the water filter into water
until no more air bubbles
escape, replace the filter.
31