Initial Use - Thermador TCM24RS Manuel D'utilisation

en

Initial use

General
Fill the appropriate container using only
pure, cold, uncarbonated water and only
roasted beans� Do not use coffee beans
that have been glazed, caramelized or
treated with other additives containing
sugar, since they will block the brewing unit�
¡
WARNING
Before the appliance can be switched on
and used, it must be assembled and
connected according to the enclosed
assembly instructions�
Setting up the appliance
● Remove any protective plastic film.
NOTICE:
Only use the appliance in a frost-free
room� If it has been transported or stored
at temperatures below 32°F, wait at least
3 hours before initial use�
● Take hold of the appliance door by the
recessed grip and open�
● Remove the water tank, rinse it and fill it
with fresh water up to the "max�" mark�
● Replace the water tank and click into
place�
● Remove the bean container, fill with
coffee beans and replace�
● Set the power switch to I and
close the appliance door�
The appliance heats up and is rinsed�
The display is activated�
"Set the language you require" appears�
● Press the M arrow button. The field
"English" has a light background� The
language can be changed�
● With the L arrow button select the
desired language�
● Press the N arrow button. The field
"Language" has a light background�
● Select the "Water hardness" with the L
arrow button�
Note:
It is important to set the water hardness
correctly to enable the appliance to accu-
rately indicate when the descaling program
should be run� The preset water hardness
is level 4�If a water softener is installed in
the house, please set the water hardness to
level 3� You can also check the water hard-
ness by asking your local water supplier�
● Use the enclosed test strip to determine
the water hardness. Briefly dip the test
strip in water and check the result after
one minute�
Level Water hardness
German (°dH) French (°fH)
1 1-7
2 8-14
3 15-21
4 22-30
● Press the M arrow button. The field
"4 (very hard)" has a light background�
The water hardness can be changed�
● Set the water hardness determined with
the K arrow button�
● Press the M arrow button�
"Complete set-up" appears�
● Press the M arrow button� The settings
are saved�
The appliance is ready to use when the
drink symbols are shown on the display�
The integrated fan switches on each time
a drink is dispensed and switches off again
after a few minutes�
9
1-13
14-25
26-38
39-54