General Information - Bresser 8020310 CM3000 Mode D'emploi

ABOUT THIS INSTRUCTION MANUAL
These operating instructions are to be considered
a component of the device. Please read the
safety instructions and the operating instructions
carefully before use. Keep these instructions for
renewed use at a later date. When the device is sold
or given to someone else, the instruction manual must
be provided to the new owner/user of the product.
This product is intended only for private use.
GENERAL WARNINGS
CHOKING HAZARD!
Keep packaging material, like plastic bags and rubber
bands, out of the reach of children, as these materials
pose a choking hazard.
RISK of ELECTRIC SHOCK!
This device contains electronic components that
operate via a power source (batteries). Children should
only use the device under adult supervision. Only use
the device as described in the manual; otherwise, you
run the risk of an electric shock.
RISK of FIRE/EXPLOSION!
Do not expose the device to high temperatures. Use
only the recommended batteries. Do not short-circuit
the device or batteries, or throw them into a fire.
Excessive heat or improper handling could trigger a
short-circuit, a fire or an explosion!
NOTE!
Do not immerse the unit in water.
Do not subject the unit to excessive force, shock, dust,
extreme temperature or high humidity, which may result
in malfunction, shorter electronic life span, damaged
batteries and distorted parts.
Do not disassemble the device. In the event of a defect,
please contact your dealer. The dealer will contact
the Service Centre and can send the device in to be
repaired, if necessary.
Use only the recommended batteries. Always replace
weak or empty batteries with a new, complete set of
batteries at full capacity. Do not use batteries from
different brands or with different capacities. Remove
the batteries from the unit if it has not been used for
a long time.
The manufacturer is not liable for damage related to
improperly installed batteries!
6

GENERAL INFORMATION

This item is available in the following variants. The
functions and technical data are the same. They only
differ in its design/in its colour.
8020310 CM3000: MyTime Thermo-/Hygro, black
8020310 GYE000: MyTime Thermo-/Hygro, white
8020310 E8G000: MyTime Thermo-/Hygro, red
8020310 WXH000: MyTime Thermo-/Hygro, blue
8020310 LXD000: MyTime Thermo-/Hygro, yellow
8020310 W9H000: MyTime Thermo-/Hygro, pink
8020310 B4K000: MyTime Thermo-/Hygro, green
8020310 5SJ000: MyTime Thermo-/Hygro, brown
SCOPE OF DELIVERY
Wall clock, Instruction manual
Required batteries: 1 x 1.5V battery (Size AA/LR6)
Batteries not included with purchase.
PARTS OVERVIEW
Wall clock (Fig. 2)
1. Dial plate
2. Clock hands (hours, minutes, seconds)
3. Humidity display (indoor)
4. Temperature display (indoor)
5. Wall mount
6. Battery compartment
7. M.SET button
8. RESET button
9. REC button
GETTING STARTED/POWER SUPPLY
NOTE!
Insert the batteries for the remote sensor first and
then insert the batteries for the wall clock. Make sure
to place the batteries strictly according to the right
polarities (+/-) as shown in the battery compartment.
1. Remove the locking pin from the clockwork.
The clock can be operated only after the pin has
been removed.
2. Insert one battery (1.5V, AA/LR6) into battery
compartment (6).
TIME SETTING
NOTE!
After the clock received the DCF time signal the time
will be set according to the Central European time
(CET). Summer and winter time change (and reverse)
is also set automatically. Other deviating times can be
set manually only.
(Fig. 1)