Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
22
ASSEMBLY
Hints for assembly
•
Please note that the packaging and transport locks must be removed
before assembly.
•
After unpacking, check for possible damage. If you are not sure, contact
qualified specialists. Keep the packaging material out of the reach of
children, as it may present a danger. Dispose of the packaging material
according to the legal regulations.
Installation steps
•
Guide the rear base (14) in the direction of the arrow into the guide of the
front base. Push the rear base forward. Fasten the rear base to the front
base with 2 M8 screws (A) and washers (B).
•
Insert the door of the gas cylinder container (7) into the slots on the side of
the housing.
Replacing the battery
•
Remove the cover of the ignition (12) by turning it counterclockwise.
Insert a battery of type LR03.
•
Insert the negative end of the battery first, then put the cover (12) back up
and tighten it clockwise.
Publicité
Table des Matières
