Dell PowerConnect W-6000 Guide D'installation page 9

CAUTION: Installation should be performed by a trained technician.
This chapter covers the following installation topics:
Precautions to observe during installation
Requirements for W-6000 controller components and rack mounting gear
Selecting a proper environment for the W-6000 controller
Mounting the W-6000 controller in a rack
Connecting power to the W-6000 controller
Pre-Installation Checklist
You will need the following during installation:
Dell PowerConnect W-6000 Controller
Dell PowerConnect W-6000 Controller rack mounting hardware (included)
Phillips or cross-head screwdriver
19-inch equipment rack, or equivalent
3U rack space with 10 cm (4 inches) clearance to the left, right, front, and rear of the rack
Another person to help position the W-6000 controller.
One power cord for each power supply, rated to at least 10 A with IEC320 connector
Adequate power supplies and electrical power (see
Cool, non-condensing air 0 to 40 ºC (32 to 104 ºF): may require air conditioning
Console terminal with RJ-45 or DB-9 serial port
RS-232 serial cable with RJ-45 male connectors
A serial adapter (included) if connecting to the console with DB-9
Dell PowerConnect W-6000 Controller | Installation Guide
Chapter 2
Installing the Chassis
"Power Management" on page 25)
Installing the Chassis | 9