Table des Matières
Publicité
ENGLISH
INSTALLATION MANUAL
Thank you for buying this JB Systems product. To take full advantage of all
possibilities, please read these operating instructions very carefully.
The JB Systems TUBELED™ system contains the following components:
• The 1m long TUBELED™ tubes: to be connected to the controller.
• The TUBELED™ controller: controls the connected led tubes.
• Signal extension cables: 5m or 10m.
• Power extension cables: 5m, 10m or 20m.
This manual only explains installation of the tubes, refer to the controller user
manual to know everything about how to use the TUBELED™ system.
FEATURES
• Each TUBELED™ uses 144 high efficiency leds.
• Suitable for outdoor use due to IP44 protection grade
• Up to 4000 tubes can be connected to the controller (not included)
• Direct mains input, no costly extra power supplies needed!
• Extended life span: 50000 – 100000 hours
• Low power consumption (P<12W)
• Solid aluminum holders for wall fixing included
• Perfect for use in: retail stores, commercial displays, architectural lighting, indoor
and outdoor decoration, clubs, pubs, mobile DJs, trussing, ...
BEFORE USE
Check the contents:
Check if the carton contains the following items:
• TUBELED™
• two aluminum holders for wall fixing
• Installation manual
Some important instructions:
• To protect the environment, try to recycle the packing material as much as possible.
• Keep this booklet in a safe place for future consultation. If you sell this unit, be sure
to add this installation manual.
• Don't use near strong magnetic fields and objects carrying high voltages.
• The electrical installation should be carried out by qualified personal.
• We strongly suggest NOT opening the unit, there are no user serviceable parts
inside.
JB SYSTEMS
INSTALLATION MANUAL
1/12
TUBELED™
ENGLISH
• In the event of serious operating problems, stop using the unit and contact your
dealer immediately.
DESCRIPTION
1. TUBELED SIGNAL INPUT: low voltage signal input to be connected with the
signal output of the previous tube or with the signal output cable from the
controller. Extra 5m or 10m signal cable extensions are optionally available.
2. TUBELED SIGNAL OUTPUT: low voltage signal output to be connected with the
signal input of the next tube. If there's no further tube to be connected, you must
seal this connector against humidity if the tubes are used in outdoor applications.
Extra 5m or 10m signal cable extensions are optionally available.
3. MAINS INPUT CABLE: To be connected with the mains output cable of the
previous tube or with any mains wall socket.
4. MAINS OUTPUT CABLE: To be connected with the mains input cable of the next
tube. If there's no further tube to be connected, you must seal this connector
against humidity if the tubes are used in outdoor applications.
5. TUBE HOLDERS: Needed to fix the tubes easily against a surface.
6. GROUND CONNECTION: Use this connection to ground the led tubes properly.
INSTALLING:
• Test each tube independently before installing: just connect each tube separately to
the mains voltage (no signal cables connected!)
white color.
• Fix all the tubes properly, using the supplied holders. The tubes are suitable for
outdoor applications; however they may NOT be used under water!!!
• Connect
the
signal
cables
of
all
tubes
together. Make sure to
fasten the plastic ring
well.
• Connect the mains cables of the tubes together.
The mains connectors have IP44 protection.
However to have full IP44 protection you must
hear a "click" when you put the connectors
JB SYSTEMS
INSTALLATION MANUAL
the tube is OK when it lights up in
2/12
TUBELED™
Publicité
Table des Matières
