Profile Preparation - Locinox FREE VINCI LFKQ X1L Mode D'emploi

5. Profile preparation

Determine the correct position of the lock in the gate frame. The mounting holes can be prepared
by means of the drawing below.
NOTE! The hole of the self-latching bolt, needs to be larger (Ø24 mm) at the back of the gate
frame then at the front (Ø18 mm). This allows you to fit the Free Vinci easily into the gate frame
when a minimum distance (110 mm) between the gate frame and the first gate bar is used.
6. Switching the codepanel to the entrance side
Before mounting the Free Vinci to the gate, check if the code entry side is at the correct side of the
gate. If not, follow the instructions below to change the codepanel to the entrance side of the gate.
Step 1: Remove the closing cover.
First remove the cover screw and then slide out the closing cover and the dust- & raincover.
6