Mounting The Handles; Turn The Rollerbolt To Match The Closing Direction - Locinox FREE VINCI LFKQ X1L Mode D'emploi

8. Mounting the handles

NOTE! The handle at the top position is the code entrance handle on the secure side of the gate.
The bottom position is for the free exit handle on the "safe" side of the gate.
CAUTION! Install the handle shaft so that the handle's set screw tightens into the spreader side
of the shaft.

9. Turn the rollerbolt to match the closing direction

CAUTION! Before mounting the Free Vinci to the gate, check if the rollerbolt is in the correct
position. If not, remove the screws and turn the rollerbolt.
NOTE! We recommend threadlocker for the rollerbolt mounting screws. Tighten the screws
securly.
180°
37