Charger Location; Dc Connection Precautions - Schumacher Electric DSR INDUSTRIAL Série INC-4825A Guide D'utilisation

3.5 If it is necessary to remove the battery from the vehicle to charge
it, always remove the grounded terminal first. Make sure all of the
accessories in the vehicle are off to prevent arcing.
3.6 Be sure the area around the battery is well ventilated while the battery is
being charged.
3.7 Add distilled water to each cell until the battery acid reaches the level
specified by the battery manufacturer. Do not overfill. For a battery without
removable cell caps, such as valve regulated lead acid batteries (VRLA),
carefully follow the manufacturer's recharging instructions.
3.8
Read, understand and follow all instructions for the charger, battery,
vehicle and any equipment used near the battery and charger. Study all
of the battery manufacturer's specific precautions while charging and
recommended rates of charge.
3.9 Determine the voltage of the battery by referring to the vehicle owner's
manual and make sure that the output voltage is correct.
3.10 Make sure that the charger cable connector makes tight connections.
4.

CHARGER LOCATION

4.1 Locate the charger as far away from the battery as the DC cables permit.
4.2 Never place the charger directly above the battery being charged; gases
from the battery will corrode and damage the charger.
4.3 Do not set the battery on top of the charger.
4.4 Never allow battery acid to drip onto the charger when reading the
electrolyte specific gravity or filling the battery.
4.5 Do not operate the charger in a closed-in area or restrict the ventilation in
any way.
5.

DC CONNECTION PRECAUTIONS

5.1 Connect and disconnect the DC output cables only after setting the
charger switch to the "off" position and removing the AC plug from the
electrical outlet.
Risk of explosion and contact
with battery acid.
4
• •