Kohler Mach Tripoint 10TD00N10-CP Mode D'emploi page 6

2. Install the Control Stop
Apply sealant tape to the supply pipe.
Install the control stop. Using a wrench, align outlet with the valve inlet.
Using the provided hex wrench, remove the cap.
Using a flathead screwdriver, verify that the control stop is closed.
Place a bucket under the control stop and turn the water supply ON.
Slowly open the control stop to flush debris.
Close the control stop.
Check for leaks between the supply pipe and the control stop.
1339618-2-C
2.5 mm
6
Close
Open
Kohler Co.