Kohler Mach Tripoint 10TD00N10-CP Mode D'emploi page 11

7. Tes t Upward-Facing Sensors
IMPORTANT! Follow the instructions below to correctly activate and test the sensor.
Remove the sticker covering the sensor.
Stay clear of the sensor for 2 minutes to allow the calibration process to finish.
Hold your hand 1" (25 mm) to 2" (51 mm) above the sensor to activate flush.
If the valve does not flush, wait 30 seconds and repeat.
Kohler Co.
2" (51 mm) -
2-5/8" (67 mm)
7" (178 mm) -
9" (229 mm)
1"
(25 mm)
Min
11
1339618-2-C