Table des Matières
Publicité
Hydraulic workshop crane SILVERLINE
English
Picking up the load
Move the cantilever arm to the desired lifting position and lock.
Check that the load capacity of the crane is not exceeded for the length of the arm.
Never exceed the load capacity specifications given below.
A1
1000kg
A2
800kg
A3
700kg
Cantilever arm position
The cantilever arm can be used in four different working positions.
Adjusting the cantilever arm:
Pull out the locking pin and pin .
Move the crane arm to the desired position.
Insert the pins in corresponding holes and fasten.
Never start using before you have checked the pin
connections and their fasteners.
Operation
Check that the safety lug for the lifting hook is properly
closed when the lifting tackle has been attached.
Lifting
Attach the pump lever to the pump lever holder.
Move the pump lever up and down to build up oil
pressure in the cylinder, (the pump lever mechanism is
equipped with a restoring spring).
If the pumping movement is interrupted, the crane arm
stays in the position it has reached.
If the stop on the hydraulic cylinder is reached during
pumping, the pressure control valve will cut in.
Once the crane has reached the stop, you must cease operating the pump lever.
Lowering
Move the lowering lever in the direction of the arrow. Adjust the speed of
lowering to the load.
Releasing the lowering lever stops the lowering movement.
A lowering brake valve independently of the load regulates the maximum lowering
speed.
technische Änderungen vorbehalten
F = 1000kg
F = 800kg
F = 700kg
A4
500kg
F = 500kg
design changes under reserve
F 09.02.136
A1
500kg
F = 500kg
A2
400kg
F = 400kg
A3
350kg
F = 350kg
A4
250kg
F = 250kg
handle
Lowering
lever
changements techniques sous réserve
Pump lever
depository
pump lever
13 / 32
Publicité
Table des Matières
