Table des Matières
Publicité
Hydraulic workshop crane SILVERLINE
English
Making ready for use:
(only ever use on a flat, horizontal floor/ground surface)
Important! Always hold unlocked wheel arms tightly! Risk of injury
Transportation
position
5. Lift the undercarriage slightly with your
foot.
6. Insert the hinge pin and fasten.
CAUTION:
When it is folded together, only ever push the crane on a
smooth and level floor/ground surface. Any obstacles (uneven
floor) may cause it to tip over.
Handling
Inspections required before starting work:
Check that the operating elements are in proper working order
Check that the parking brake is in proper working order
Check the condition of the castors and the castor axles
Check the hook and the load bearing mechanism
Carrying and steering with the handle
The crane is only suitable for carrying loads over short distances.
Carry the load at as low a height above the floor/ground as possible.
When carrying the load it is imperative that the load is not permitted to swing or rock. Use
only the handle to move the crane. Never use the lowering lever or the pump lever to do so.
Since the crane only has a single parking brake it must never be used on slopes and
gradients.
The parking brake must always be on during lifting and setting down.
technische Änderungen vorbehalten
Swinging down the upright bar
1. Unlock the upright bar (pull out the locking pin ) and
move to the function position (direction of arrow).
2. Remove the retaining pin (slacken the stop spring).
3. Unlock the pin .
7. Lock and fasten the hinge pin.
design changes under reserve
F 09.02.136
Lowering lever
changements techniques sous réserve
4. Swing down the
undercarriage bar
(Check that there is
sufficient room to
maneuver. There must be
no objects in the
maneuvering area. The
operator must ensure that
any other persons in the
vicinity keep a safe
distance from the crane!)
8. Once the first undercarriage
bar has been locked and
fastened, swing down the
second undercarriage bar and
lock and fasten.
9. Check that all locks and
fasteners are fixed tightly.
10. To return to the transportation
state, follow the above
instructions in reverse order.
Pump leverl
Handle
re lease
lock
12 / 32
Publicité
Table des Matières
