Maintenance - Textron Greenlee Utility HW1 Mode D'emploi

Operation
Note: Allow the power source to run for a few
minutes to warm the hydraulic fluid.
Do not change the position of the directional spool
before changing direction.
Failure to observe this precaution can result in
property damage.
of the tool or on the auxiliary handle. This will allow
you to apply leverage while operating the tool.
ment to achieve the necessary amount of torque.
H
impacting will cause severe wear on the impact
mechanism.
to reduce heat and wear on tool components.
Greenlee / A Textron Company
1.800.544.2843
M
L
TORQUE
H
www.calcert.com
15
10 20
5 25
0 30
HW1 and HW1V Impact Wrenches

Maintenance

Wear eye protection when operating or
servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris or hydraulic oil.
result in serious injury.
Failure to observe this warning could result in severe
injury or death.
service life.
Note:
Keep all decals clean and legible, and replace when
necessary.
When disposing of any components (hydraulic hoses,
hydraulic fluid, worn parts, etc.), do so in accordance
with federal, state, and local laws or ordinances.
Daily
1. Wipe all tool surfaces clean.
2.
tool is disconnected.
Monthly
Perform a thorough inspection of the hydraulic hoses
11
sales@calcert.com