Textron Greenlee Utility HW1 Mode D'emploi page 7

Specifications
Impact Wrench
Hydraulic Pressure Port ...
Hydraulic Return Port ........
Torque ..................................................
.........................................1/2" square drive w/
...................................................... 11 m/s
..........................................................
Mass/Weight
HW1 .......................................................
HW1V .....................................................
........................................................
Width ..........................................................
Height .......................................................
Hydraulic Power Source
Do not exceed the following hydraulic power source
Failure to observe this warning could result in severe
injury or death.
Flow
Minimum .........................................
Recommended .............
Maximum .........................................
Filtration .............................................
Greenlee / A Textron Company
1.800.544.2843
.............................
...................................................... 6500
...............................
.............................
........................
..................
www.calcert.com
15
10 20
5 25
0 30
HW1 and HW1V Impact Wrenches
Hydraulic Power Source
1. Maximum hydraulic fluid temperature must not
capacity is needed to limit the hydraulic fluid
temperature.
Install a flow meter in the return line to measure the
rate of hydraulic flow before using the tool.
to limit excessive hydraulic pressure to the tool.
2
Hydraulic Schematic
RELIEF
VALVE
138 bar
RESERVOIR
(2000 psi)
CONTROL
VALVE
PUMP
POWER SOURCE
Recommended Hydraulic Fluids
.............................................. 140 to 225
........................................... 40 minimum
Flash Point ................................
Pour Point ..................................
FILTER
(10 MICRON)
COOLER
T
FLOW METER
P
sales@calcert.com
TOOL