Subaru E721SAN030 Serie Instructions D'installation page 8

PART NUMBER: E721SAN030XX
STEP 11: When ready, position hands over the RH clip and press down vertically to engage the clips. You will hear a series of clicks. Then
proceed to the LH clip and make sure the T-bolt is still aligned with the clip. Press down to engage the clips. You will hear a series of click.
CAUTION: Failure to align the T-bolt to the white clip can cause the white clip to be damaged and pressed into the hole.
#1
#2
STEP 12: Open trunk lid and install the 4 (four) compression nuts. Loosely tighten all 4x nuts then torque using the following
sequence below.
Torque: 5.65 +/- 0.40 N•m (50 in-lbs +/- 3 in-lbs).
1/4" Drive
1/4" Drive
Torque Wrench
Deep Socket
1/4" Drive Ratchet
PART NUMBER: ISSUE
SUBARU OF AMERICA
6/17/2021 PAGE 8 / 17
E721SAN030XX 00