Subaru E721SAN030 Serie Instructions D'installation page 14

PART NUMBER: E721SAN030XX
STEP 27: Install the adjustable trunk support rod extending from the spare tire well area to the trunk lid.
WARNING: If the adjustable support rod is not securely installed, the trunk lid can fall when the torsion bars are removed and cause
severe injury to the installer and/or damage to the vehicle.
STEP 28: Locate the bracket clip at the center of the trunk and open it by releasing the tab in the front and then swinging the bracket
rearward to open.
NOTE: Take notice of the order of the torsion bars in the bracket before proceeding.
RH Torsion Bar
To Be Removed in
Step 32
LH Torsion Bar
To Be Removed
in Step 30
STEP 29: CAUTION: The next few steps must be performed carefully with the specified torsion bar removal tool. Failure to use the proper
tool can result in severe injuries and/or damage to the vehicle. Due to this, it is strongly recommended that this product be installed by a
Subaru retailer.
Left Hand (LH) Torsion Bar Removal: With the special tool securely in place and safety pin engaged, rotate tool downward to apply tension
to the LH torsion bar on the right-hand side of the vehicle.
PART NUMBER: ISSUE
SUBARU OF AMERICA
6/17/2021 PAGE 14 / 17
E721SAN030XX 00