Subaru E721SAN030 Serie Instructions D'installation page 15

PART NUMBER: E721SAN030XX
STEP 30: While tensioning the LH torsion bar, move the RH hinge link off the LH torsion bar (1). Then carefully unhook the torsion bar off
the RH hinge bracket (2) - see diagram (photo taken from rear seat) to lift up and then carefully pull towards the rear. Dislodge torsion bar
from the bottom position of the center bracket clip (3).
(2) RH Hinge Bracket
(3) Center Bracket Clip
(not shown)
(1) RH Hinge Link
LH Torsion Bar
STEP 31: While still holding the torsion bar tool, support the center of torsion bar with other hand and angle it downward (1). Remove
torsion bar from the anchor bracket by pulling to the right (2). Remove safety pin and remove the tool from the torsion bar. Dispose of the
original torsion bar.
PART NUMBER: ISSUE
SUBARU OF AMERICA
6/17/2021 PAGE 15 / 17
E721SAN030XX 00