Subaru E721SAN030 Serie Instructions D'installation page 5

STEP 6 – See STEP 6A if using a metric step drill bit. Skip to 6B if using an SAE step drill bit.
STEP 6A: Metric Hole Drilling: Use tape to mark the stopping position on the step drill bit. Drill the 7 (seven) hole locations according to the
sizes as shown below.
STEP 6B – SAE Hole Drilling: Use tape to mark the stopping position on the step drill bit. Drill the 7 (seven) hole locations according to the
sizes as shown below.
PART NUMBER:
E721SAN030XX
PART NUMBER: E721SAN030XX
ISSUE
6/17/2021
00
Your step drill bit
may look different
than the one shown.
Confirm the proper
stopping step before
drilling.
25/64"
Your step drill bit
may look different
than the one shown.
Confirm the proper
stopping step before
drilling.
SUBARU OF AMERICA
8mm
10mm
13mm
5/16"
1/2"
PAGE 5 / 17