Parker PSE 325 Manuel D'utilisation page 11

Touch to reset alarm(s). Remember that alarm reset should only be
done once the nominal operating conditions have been restored.
6.3.3 Probe menu
Touch to enter menu
Touch to move forward to next screen
real-time probe values are displayed:
B0 : Dew point temperature
B2 : Evaporator temperature
B8 : Discharge compressor temperature
B5 : Suction compressor temperature
P1 : High pressure (condenser)
English
6.3.4 Digital input menu
Touch to enter menu
Local ON/OF: green when remote start contact is closed, otherwise it
is gray.
Condensate level: green when there is condensation to drain, otherwise
it is gray.
Monitoring phase: green when phase sequence is correct, otherwise
it is gray:
Compressor protection: green when compressor protection is in the
normal operating position, otherwise it is gray.
High Pressure switch: green when pressure switch protection is in the
normal operating position, otherwise it is gray.
Low Pressure switch: green whenpressure switch protection is in the
normal operating position, otherwise it is gray.
PSE 325-1000 60Hz
6.3.5 Digital output menu
Touch to enter menu
General alarm:green when general alarm contact is closed, otherwise
it is gray.
Compressor: green when compressor start contact is closed, otherwise
it is gray.
Condensate drain: green when condensate drain contact is closed,
otherwise it is gray.
Plan Status: green when "dryer ON" contact is closed, otherwise it is
gray.
Hot gas bypass valve: green when bypass valve contact is closed
(valve open), otherwise it is gray.
9/12