Mopar Systeme de demarrage a distance Jeep Wrangler JK 2007 Notice D'installation page 9

Parking Light Connection
F. Locate the White/Violet (L217) wire in
the harness found driver's sill panel
area. Center-splice the harness
White/Violet wire into this wire,
following the center-splice procedure.
This wire will show +12V when the
parking lights are turned on.
G. Route the three remaining wires (Black/
White, Dk Green and Grey) through the
cowl panel and into the engine compart-
ment through an existing grommet.
Horn Connection
H. Locate the Grey/Yellow (X21) wire in the
green "C" connector (pin #18) found
underneath the TIPM module. Center-
splice the relay harness Grey wire (pin
30) into this wire, following the center-
splice procedure. Solder the connection.
This wire will show +12V when the horn
is activated.
I. Connect the relay harness Red wire (pin
87) to the positive battery post.
J. Route the remaining relay harness Dk
Green wire (pin 85) to the Dk Green (-)
HORN output wire on the main remote
start harness. Solder the connection.
1 2 3
1 2 3
1 2 3
1 2 3
9