Mopar Systeme de demarrage a distance Jeep Wrangler JK 2007 Notice D'installation page 8

Custom Harness Installation
Ignition switch connector
A. Locate ignition switch connector,
directly behind the ignition switch.
Release the secondary lock. While
pushing on main release, remove
connector from ignition switch.
B. Connect the harness 5-way female
connector to the vehicle's ignition
switch.
C. Connect the harness 5-way male
connector to the vehicle's 5-way
ignition connector previously
removed from the ignition switch.
Ground
D. Using the supplied 1/4" screws,
secure both black ground wires with
ring terminals to the metal of the
driver's side kick panel.
Brake Connection
E. Route the harness Dk Green/White
wire to the brake switch. Center-splice
to the White/Dk. Green (L51) wire in pin #6
of the 6-way black brake connector
(D2293).
Caution: Keep wire away from
exposed steering column!
Caution: Do not remove the
brake lamp switch from the
mounting bracket. If the switch
is removed from the mounting
bracket, it MUST be replaced
with a new switch.
8
1 2 3
1 2 3
Center-Splice Procedure
1 2 3
1 2 3
1 2 3