System Testing; Service Mode - Mopar Systeme de demarrage a distance Jeep Wrangler JK 2007 Notice D'installation

System Testing

Use the following checklist to ensure all features function as indicated.
Remote start - Press start button 2X.
Remote stop - Press and hold start button for 2 seconds.
Hood safety switch shutdown - While under remote start, open hood - engine should shut down.
Brake safety shutdown - While under remote start, press brake - engine should shut down
Key-in-sense circuit - With key in the ignition cylinder, remote start should not activate.
Overrev shutdown - While under remote start, press accelerator - system should shut down at 3X idle.
Service Mode - With ignition turned on with key, press remote start button 3X. Repeat to exit Service Mode.
Heater/Air Conditioning - Ensure Heater/AC works during remote start.

Service Mode

Service mode is used whenever it is necessary to disable the remote start
feature, such as during vehicle service. The vehicle will not start by remote if
Service mode is activated.
Entering Service mode
A. Turn ignition on with the key.
B. Press the start button on the remote transmitter 3 times. 2 seconds later,
the horn will chirp and the lights will flash 3 times, indicating the system
is in Service mode.
C. While in Service mode, whenever a remote start attempt is made, the
horn will chirp and the lights will flash 3 times alerting the user that the
system is in Service mode.
Exiting Service mode
A. Turn ignition on with the key.
B. Press the start button on the remote transmitter 3 times. 2 seconds later,
the horn will chirp and the lights will flash 1 time, indicating the system
has exited Service mode.
1 6