Mopar Systeme de demarrage a distance Jeep Wrangler JK 2007 Notice D'installation page 10

Connect to (-)HORN output (pin #21)
from remote start module
Dk Green/Violet wire
Connect to Grey/Yellow (X21) at
TIPM Green "C" Connector (pin #18)
Hood Switch Connection
K. Connect the Black/White wire to
the remaining wire from the hood
safety switch. Solder the connec-
tion.
Tach Connection
L. Route the Grey wire to the top of the
engine at the coil connector as shown.
Center-splice the harness Grey wire
into the vehicle Dk Blue/Dk Green
(K19) wire at the coil. Solder the
connection.
Control Module Connections
M. Connect the 24-way and 10-way
connectors into the PC-12 Remote
Start module. Also, connect the 2-
way antenna connector (on end
opposite the main harness connec-
tions).
1 0
Horn Connection
Dk Green
85
(+)
Grey
87
87a
86
30
20A Fuse
Red
Antenna
24-Way 10-Way