Mopar Systeme de demarrage a distance Jeep Wrangler JK 2007 Notice D'installation page 11

Install SKREEM Interface
A. Following the directions on the supplied
ampule of adhesive primer. Apply a thin
coating of primer to the entire SKREEM
transceiver antenna coil. Allow the primer
to dry for 5 minutes before proceeding to
the next step. Note: Use goggles and
gloves to protect yourself from any acci-
dental contact.
B. Remove backing from one side of the sup-
plied two-way tape and apply tape around
the SKREEM transceiver antenna coil.
C. Remove the remaining backing on the
tape and position the antenna loop on
the tape around the SKREEM trans-
ceiver antenna coil, with the red stripe
side facing out toward the key open-
ing. Press down on antenna coil to
ensure a strong bond.
D. Using a supplied wire tie, secure
the antenna coil.
E. Re-install the SKREEM module to the
ignition cylinder and secure with the
screw. Make sure to plug the connec-
tor back into the SKREEM module.
Transceiver Antenna Coil
1 1