Component Installation - Mopar Systeme de demarrage a distance Jeep Wrangler JK 2007 Notice D'installation

Component Installation

Install Hood Safety Switch.
A. Using (2) of the supplied 1/4" screws,
secure hood safety switch on driver's
side of hood per the diagram. Note:
Wire exits top of switch. Switch must
be bent at 45 degree angle.
B. Using a supplied 1/4" screw, secure
the ground lead from the switch to the
metal cowl panel. The remaining wire
will be connected later.
C. Locate a visible area in the front of
the engine compartment to mount
the underhood warning sticker.
Install Dipole Antenna.
D. Mount dipole antenna to the
windshield above the rearview
mirror and below the black wind-
shield trim.
E. Route the antenna wire above the
headliner to the driver's A-pillar.
Temporarily remove the A-pillar
rubber gasket and run the antenna
lead down through the left side
dash opening. Replace the rubber
gasket. Ensure the antenna is
securely tucked above the head-
liner and is not visible along the
entire length.
PLUG
BRACE
7