Mopar Systeme de demarrage a distance Jeep Wrangler JK 2007 Notice D'installation page 4

Overview
The remote starter module harness will interface with the existing ignition switch connec-
tor, four center-splice connections, and two ground terminations. Three wires will be
routed through the cowl panel, to a hood-mounted safety switch, horn and tachometer
connection.
Vehicle Preparation
Remove driver's side lower dash panels,
& steering column shroud.
A. Pull down on lower dash. Panel is
held by clips. Start at the top corners.
Remove panel.
B. Remove (3) bolts holding metal panel
in place. Pull up on the panel to
remove.
C. Remove lower plastic dash panel.
Panel is held by clips.
D. Remove (3) screws from steering
column shroud. Separate and remove
steering column shroud.
E. Remove driver's side kick panel/sill
plate. Panel is held on by clips.
4