Winter Application; General Maintenance - AquaScape 91142 Mode D'emploi

• The Pond Powerhead is rated for use between 8 and 14
volts without damaging the motor. When running longer
cable lengths and/ or connecting multiple units, the Pond
Powerhead may be susceptible to voltage drop, providing
diminished flows. For installations susceptible to voltage
drop, we recommend the use of a larger gauge cable
(12 to 16-gauge), for extensions. The larger gauge cable
will help to maintain the proper voltage for each motor.

Winter Application

• The Pond Powerhead makes it easy to winterize ponds, as the powerful flow of
water positioned just below the surface of the pond will keep a hole open in the ice
and ensure proper gas exchange to keep fish safe during cold winter months. The
flat-bottomed design provides a sturdy base for quick and easy placement below
the surface of the pond (Ex. 8). Bricks or stones can be used if needed to raise the
Powerhead to the proper height.
• If running through winter conditions, check regularly to make sure it is functioning
properly. Non-running powerheads positioned close to the surface where ice forms
should be removed to prevent damage. When removing the powerhead for the
winter, clean with fresh water and store the pump in a frost-free location.

General Maintenance

• Over time, depending on conditions, the powerhead may collect debris around the outside of the unit. Remove this debris
from the outside of the unit to provide maximum water flow.
• Outer/Inner Cage Cleaning:
– Remove the single screw located at the center of the unit (Ex. 9). Depress all three external tabs and gently lift upward to
remove the front cage (Ex. 10).
– Clean the exterior and interior of the cage to remove any existing debris or buildup. If needed, use Aquascape Pump
Cleaner Maintenance Solution (#91143) to remove stubborn buildup.
• Propeller Cleaning:
– Remove the water chamber cover by rotating it counter-clockwise and gently pulling (Ex. 11).
– Remove the propeller by pulling gently.
– Clean the propeller and internal pump body with Aquascape Pump Cleaner Maintenance Solution (#91143), using a
sponge or soft-bristled brush.
– When reinstalling the propeller, be sure to align the three tabs with the corresponding indentations before locking into
place (Ex. 12).
– When reinstalling the cage, be sure to align the screw with the proper external tab.
2
B
A
2
☎
aquascapeinc.com |
1
2
B
B
A
A
Ex. 9
1
2
☎
CAN (866) 766-3426 |
US (866) 877-6637
• Plug the quick-connect
fitting into a 12-Volt,
outdoor-rated transformer
or existing low-voltage
system. The Pond
Powerhead is designed to
operate on a power source
with a maximum operating
range of 9V-15V. Operating
the powerhead outside of
this voltage range voids the product warranty (Ex.7).
2
1
B
B
A
A
Ex. 10
2
1
2
1
B
B
A A
Ex. 11
1
2
Ex. 7
Ex. 8
1
B
A
Ex. 12
1
5