Contents; Safety Information; Important - AquaScape 91142 Mode D'emploi

Contents

No. Description
1. Pond Powerhead

Safety Information

WARNING: Risk of electric shock – This pump
has not been approved for use in swimming
pool or marine areas.
WARNING: To provide continued protection
against risk of electric shock, connect to
properly grounded, ground fault circuit
interrupter (GFCI) outlets only, using the
following guidelines:
(A) Have a qualified electrician install a properly grounded
receptacle outlet, acceptable for outdoor use and
protected from snow and rain.
(B) Inspect cord before using.
(C) Do not use extension cords.
• Always operate the pump fully submerged. Failure to do
so may overheat the pump and cause it to fail, voiding the
warranty.
• Use only in fully assembled state, paying particular
attention to ensure that outer filter screen is attached to
the pump. Failure to operate the pump without the filter
screen will allow large debris to enter the pump and cause
the pump to fail, voiding the warranty.
• Do not wear loose clothing that may become entangled in
the propeller or other moving parts.
• Keep clear of suction and discharge openings. DO NOT
insert fingers into pump with power connected.
• Do not pump hazardous materials or liquids, such as oil,
saltwater or organic solvents.
• Do not block or restrict discharge.
Maximum Flow
Motor Type
Rate (GPH)
Approximately
Mag-Drive
2,000
☎
aquascapeinc.com | CAN (866) 766-3426 |
Pond Powerhead Specs
Input Voltage Input Frequency
12V 60Hz
☎
US (866) 877-6637
1
(D) Any wiring of pumps should be performed by a
qualified electrician to ensure code compliance and
user safety.
(E) Unplug pump at receptacle outlet when not in use or
before removal from pond.
(F) To reduce risk of electrical shock, all wiring and
junction connections should be made per local codes.
Requirements may vary depending on usage and
location.
(G) The power cable should be protected at all times to
avoid punctures, cuts, bruises and abrasions.
(H) Never handle power cords with wet hands.
(I) Do not remove cord. Do not connect conduit to pump.
(J) Do not use power cable to lift pump.
• Products returned must be cleaned, sanitized, or
decontaminated, as necessary, prior to shipment to
ensure that employees will not be exposed to health
hazards in handling said material. All applicable laws and
regulations shall apply.
IMPORTANT: Aquascape, Inc. is not
responsible for losses, injury, or death
resulting from a failure to observe these safety
precautions, misuse or abuse of pumps or
equipment.
• The Pond Powerhead is a thermally protected,
submersible pump for outdoor or indoor use and has been
evaluated for use with water only.
Power Cord
Wattage Amperage
40 3.33
Pump
Length Dimensions
25' 9.75"L x 5.75"W x 5.75"H
3