R&G CP0230BL Instructions De Montage page 3


Take M12 x 150mm long cap head bolt (longest) and washer and put through the front hole in spanning bar
so washer goes into counter-bore, place longer spacer with groove over exposed end of bolt with shorter flat
portion against spanning bar as shown above.

Take M12 x 100mm long cap head bolt and washer and put through the rear hole in spanning bar so washer
goes into counter-bore, place longest spacer with step over exposed end of bolt with larger diameter against
spanning bar as shown above.

Offer the assembly up to bike placing front (longer) bolt through plain mounting at front of engine and
shorter bolt through plain frame mount and engine mount as original (shown top right). Be sure to check
both top radiator cowls are clear of both crash protector assemblies.

Using OEM nuts on both bolts tighten evenly. Do not overtighten as damage can occur to the bike. Do not
exceed 40nm of torque.

Install one of the hex-head bolts with a flat washer followed by a shake proof washer into bobbin so the head
sits in the counter-bore and offer up to spanning bar if all of the above has been done correctly the bobbin
should sit in the shaped recess so tapered end points towards rear of bike as shown top right. Tighten bolt. Do
not overtighten as damage can occur to the bike. Do not exceed 40nm of torque.

Fit cap and bubble sticker as shown top left.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The
Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other than those
in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for
its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify
any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the
motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a
replacement or refund the purchase money but shall not be liable if the Products have been modified or used or maintained otherwise
than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident or
neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be
liable for indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or
the fitting or service concerned. These terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were
purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-
sellable condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value
exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No returns of
discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty
goods.
Unit 5K, Blacknest Industrial Park, Blacknest Road, Alton, Hampshire, GU34 4PX
Tel: +44 (0)870 220 6380 Fax: +44 (0)1420 521101
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
R&G Racing
www.rg-racing.com Email: info@rg-racing.com