Cleaning The Unit; Disposal Of The Unit - SCHOTT Instruments CT 52 Mode D'emploi

26. Cleaning the unit

Before cleaning the unit, disconnect the power plug from the mains socket!
Prevent humidity from entering into the circulator CT 52 E.
27. Maintenance

28. Disposal of the unit

Cleaning the unit
For cleaning the bath tank and the immersed parts of the circulator,
use low surface
Clean the outside of the unit using a wet cloth and low surface
tension water.
The tranparent-thermostat CT 52 is designed for continuous
operation under normal conditions. Periodic maintenance is not
required.
The tank should be filled only with a bath liquid recommended by
SCHOTT Instruments GmbH . To avoid contamination, it is
essential to change the bath liquid from time to time..
Repairs
Before asking for a service technician or returning a SCHOTT
Instruments GmbH circulator for repair, please contact an
authorized service station.
SCHOTT Instruments GmbH
Hattenbergstrasse 10
D-55122 Mainz / Germany
Tel. +49 61 31 / 66 51 11
Fax +49 61 31 / 66 50 01
E-mail: avs@schottinstruments.com
www.schottinstruments.com
When returning a unit, take care of careful and adequate packing.
SCHOTT Instruments GmbH is not responsible for damages that
might occur from insufficient packing.
Disposal with household waste (unsorted waste) or similar collections of
municipal waste is not permitted!
Contact an authorized waste management company in your country.
tension water (e.g., soap suds).