Presentation - hergom H-02/22 Instructions D'installation, De Service Et D'entretien

The H-02/22 and H-03/80 fireplace/heaters have a maximum wattage of 25 kW
(17 kW power yielded to water and 8 kW power yielded to the environment).
1. H-02/22 HEATER/FIREPLACE with decorative cast iron front and plate steel
container, and a maximum wattage of 25 kW (17 kW power yielded to water and 8 kW
power yielded to the environment). Supplied fully factory assembled.
2. H-03/80 HEATER/FIREPLACE Plate steel container and cast iron adaptor for
front assembly.
The H-03/80 heater/fireplace is supplied as standard without the cast iron front.
You can purchase and assemble one of the three models of front available in our
catalogue: PLANE front, CURVO front and CLASSIC front. (These fronts are sold
separately).
The assembly instructions for fixing the front to the H-03/80 fireplace are supplied
with the front (Front assembly instruction
WARNING!
Before installing the optional front, bear the following in mind:
The position of the glass cleaning deflector is in the correct position for assembly of the
CLASSIC fronts (See Figure 1).
option, you will need to change the position of the deflector. To do so, follow these
instructions:
the glass cleaning
deflector
Fig.1
Note: For the general
dimensions of the H-03/80
fireplace/heater with the
fronts mounted, see the
"DIMENSIONS" section.

1.- PRESENTATION

manual).
If
the assembly front is the PLANE and CURVO
1. Loosen the three screws with
washer used to attach the
deflector.
2. Remove the two separator
plates (se Figure 2), which are
not required for the Classic
front.
3. Tighten the three screws and
washers of the glass cleaning
deflector again.
the glass cleaning
deflector
14
Separator plates
Fig.2