Regular Cleaning - STAMOS Soldering 6105 S-LS-6 Manuel D'utilisation

REPLACEMENT OF HOT AIR REWORK HEATING ELEMENT
1
2
3
4
5
6
1. Before heater replacement make sure that the HOT AIR gun is completely cold.
2. Remove the screws in the gun covers.
3. Unscrew the element of the handle (2) and take off the gun covers.
4. Gently remove the fan and remove the wire board screws.
5. Disconnect the heater from the wire board (pay attention to the wires connection
order).
6. Remove the heater from the housing, pay attention to the steel grounding wire.
7. New heater should be wrapped with new mica paper and then it should be placed
inside the housing.
20
EN
1. HOT AIR gun covers
2. element of the handle
3. heater
4. heater cover
5. outlet pipe
6. nozzle
REPLACEMENT OF THE SOLDERING IRON TIP AND SOLDERING
IRON HEATING CORE ELEMENT
4
3
2
1
7
9
6
BEFORE HEATER REPLACEMENT MAKE SURE THAT THE SOLDE-
RING IRON IS COMPLETELY COLD.
1. SOLDERING IRON TIP REPLACEMENT: remove the nut for mounting the solde-
ring iron tip housing and take off the housing. Replace the tip with the new one,
place the housing and fix all with the plastic nut.
2. HEATER REPLACEMENT: remove the nut for mounting the soldering iron tip
housing and take off the housing along with the tip. Remove the nut for fixing the
heater (4) and gently remove the heater (6) along with the board with wires (7).
Replace the whole remembering the wires connection order.

REGULAR CLEANING

Generalities
• Never clean the device with a pressurized water-jet, industrial cleaners, and brus-
hes or any other type of cleaning utensil that could damage the surface of the
appliance.
• Before cleaning you must remove the electricity supply plug isolating the app-
liance from the main power circuit.
EN DE
5
1. nut for mounting the sol-
dering iron tip housing
2. soldering iron tip housing
8
3. soldering iron tip
4. plastic nut for mounting
the heater and the board
wires
5. spring
6. heater
7. wires board
8. handle
21