Alto POSEIDON 1200 Notice D'utilisation page 34

5.2.3 Buildings and Equipment
Task Accessories
General Foam injectors Stan-
surfaces dard lance
Curved lances
Metallic Tank cleaning heads
equipment
Detergents
Intensive
J25 Multi
Combi Aktive
Alkafoam
Disinfectant
DES 3000
Rusted or Wet Sandblasting
damages equipment
surfaces prior
to treatment
These are merely several examples of cleaning tasks that can be solved by a pressure washer in
association with accessories and detergents. Each cleaning task is different, so please consult your
local dealer or ALTO representative in order to discuss the best solution for your own cleaning problem.
34
All manuals and user guides at all-guides.com
Method
1. Apply thick foam over the surfaces to be cleaned.
Apply on dry surfaces. Apply from top to bottom on
vertical surfaces. Let the foam act for up to 30
minutes for the optimal effect.
2. After this time, clean down with the high pressure
lance or relevant accessory. Use high pressure to
dislodge large amounts of incrusted dirt or grime.
Use lower pressure and high water volume in order
to rapidly flush away loose dirt and rinse surfaces.
3. Apply DES 3000 disinfectant once the surfaces are
perfectly clean.
Areas covered by amounts of loose dirt, such as animal
remains in slaughterhouses, can be removed by using
high water flow to flush away the dirt to evacuation pits
or drains.
Tank cleaning heads can be used to clean barrels, vats,
mixing tanks etc. Cleaning heads may be hydraulically
or electrically powered and give the possibility for
automatic cleaning without a constant user.
1. Connect the sandblasting lance to the pressure
washer and place the suction tube in the sand.
2. Always wear protective equipment during
sandblasting.
3. Spray the surfaces to be treated with the mix of
water and sand. Rust, paint etc will be stripped off.
4. Following sandblasting, protect surfaces against rust
(metal) or rot (wood).