Operation; Status Indication; User Interface; Charging Process - Ingeteam INGEREV FUSION Série Manuel D'installation Et Usage

Ingeteam

11. Operation

The main function of the charging station is to supply and measure electrical energy for users that have prior
authorization with an RFID card reader system, except in stations configured without authentication.
This section describes the operation of the charging station in detail.

11.1. Status indication

The charging station indicates its current status by means of light signals. It has independent indicators for each
power socket.
Status
Awaiting vehicle
Awaiting charge
Charge
Reduced consumption
Incident
Standby
End of session
Card rejected

11.2. User interface

The display is divided into two independent areas, one for each available socket.
The interface guides the user's charging process.

11.3. Charging process

Depending on the client's requirements, the charging process will start with or without authentication. The process
for each case is described below.

11.3.1. Charging process with authentication

CAUTION
The electrical supply connector must not be removed from the vehicle while the charging is being carried out.
Starting the charge process
1. Check that the charging station is in awaiting vehicle status with the green light.
40
Lighting
Continuous green The charging socket is waiting for a vehicle to be connected in order to
proceed with charging.
Flashing yellow A user has identified a card using the reader and the socket is waiting for
the user to connect their vehicle to the station.
Continuous blue A vehicle has been connected to the charging station.
Flashing blue The consumption is reduced
Continuous red There is an error in the station or the charging process is not being
performed correctly.
None The charging station has been remotely shut down.
Continuous yellow The charge has finished.
Continuous red The card is not valid or has not been recognized.
Description
ABW2011IQM01_D - Installation and Operation Manual
Operation