Loading Factory Settings; Saving A Flash Image File - Monacor WALL-05DT Mode D'emploi

7.9 Loading factory settings

Use the menu item "File Load Factory Settings" to load factory
settings . There are two different types of files:
– The factory file contains presets with the corresponding settings
and access rights .
– The flash image file (* .ffi) also contains the complete firmware,
i . e . when the function "Load Factory Settings" is used and a "* .ffi"
file is loaded, a firmware update will be made at the same time .
(Please observe the notes in chapter 7 .2 .5 .1 .)
Access Rights
Load Presets (Menu: Open, Restore Presets)
Save Presets (Menu: Save, Backup Presets)
Load Factory File (Factory Settings)
Create Flash Image
Change Access Rights for User level
Change Access Rights for Locked level
Change Unit Name
Change Unit Configuration (Network, AutoStandby, Startup Preset)
Upgrade the Unit Firmware
Master Volume Control
Tone Control
Access Input Channel
Access Output Channel
Fig. 16 Available access rights and their presets

7.10 Saving a flash image file

For backup or for transferring settings to another unit, all settings,
presets and the firmware of a unit can be saved to a flash image file:
Call up the menu item "File Create Flash Image" and select a file
name and a storage location . Such a file can be loaded via the menu
item "File Load Factory Settings" (
Administrator
✔
✔
✔
✔
✔
✔
✔
✔
✔
✔
✔
✔
✔ = allowed ☑ / ☐ = allowed/not allowed, selectable
☞
chapter 7 .9) .
Access Levels
User Locked State
☑
☑
☐
☐
☐
☐
☑
☑
☐
☐
☐
☐
☐
☐
55